Skoda OCTAVIA Workshop Manual page 91

OCTAVIA
Notes:
♦ Assignment of drive shafts
⇒ electronic catalogue of original parts
♦ Grease joint if necessary, when replacing
the joint boot
♦ On tripod joints only apply grease in the joint,
never in the joint boot.
1 - Joint boot with inner CV joint
♦ inspecting for tears and chafing points
♦ assignment ⇒ electronic catalogue of
original parts
2 - Warm-type clamp
♦ replace
♦ tighten ⇒ page 40-42, Fig. 8
3 - Fillister head screw with internal ser-
ration
♦ replace after each disassembly
♦ initially tighten to 10 Nm, subsequently
tighten crosswise to tightening tor-
ques
M 8 = 40 Nm
M 10 = 70 Nm
♦ assignment ⇒ electronic catalogue of
original parts
4 - Shim
♦ assignment ⇒ electronic catalogue of
original parts
Edition 06.05
S00.5103.68.20
Front Wheel Suspension
5 - Joint part
♦ grease ⇒ page 40-62
♦ assignment ⇒ electronic catalogue of
6 - Tripod spider with rollers
♦ chamfer -arrow- points toward the
7 - Circlip
♦ replace
♦ insert in the groove on the shaft
8 - O-ring seal
♦ replace
9 - Cover
♦ replace
10 - Warm-type clamp
♦ for tripod joint
♦ always replace
11 - Joint boot for tripod joint
♦ inspecting for tears and chafing points
♦ assignment ⇒ electronic catalogue of
12 - Drive shaft
♦ assignment ⇒ electronic catalogue of
13 - Warm-type clamp
♦ replace
♦ tighten ⇒ page 40-42, Fig. 9
14 - Disc spring
♦ fitting location ⇒ page 40-41, Fig. 4
15 - Thrust ring
♦ fitting location ⇒ page 40-41, Fig. 4
16 - Circlip
♦ replace
♦ insert in the groove on the shaft
17 - Outer CV joints
♦ must be replaced completely
♦ removing ⇒ page 40-40, Fig. 1
♦ installing: drive onto the shaft with a
♦ grease ⇒ page 40-62
♦ inspecting ⇒ page 40-45
♦ assignment ⇒ electronic catalogue of
original parts
drive shaft serration.
original parts
original parts
plastic hammer until the compressed
circlip expands
original parts
40
------------ 40-57 ------------