Skoda OCTAVIA Workshop Manual page 72

40
------------ 40-39.1 ------------
Front Wheel Suspension
Servicing drive shaft with outer and
inner CV joint VL 3700
Special tools, testers and aids required
⇒ page 40-38
Notes:
♦ Assignment of the drive shafts
⇒ Electronic catalogue of original parts
♦ Grease joint if necessary, when replacing
the joint boot.
1 - Outer CV joint
♦ must be replaced completely
♦ removing inspect for tears and chafing
♦ remove ⇒ Fig. 1
♦ installing: drive onto the shaft with a
♦ grease ⇒ page 40-62
♦ inspect ⇒ page 40-45
2 - Circlip
♦ replace
♦ insert in the groove on the shaft
3 - Thrust ring
♦ Fitting location ⇒ Fig. 4
4 - Disc spring
♦ Fitting location ⇒ Fig. 4
5 - Clamp
♦ replace
♦ tighten with tensioning pliers, e.g.
6 - Joint boot for outer CV joint
♦ material: Hytrel (Polyelastomere)
♦ inspect for tears and chafing points
♦ fitting location for left shaft ⇒ Fig. 14
♦ fitting location for right shaft
♦ assignment ⇒ electronic catalogue of
7 - Clamp
♦ replace
♦ tighten ⇒ Fig. 9
8 - Left drive shaft (solid shaft)
♦ assignment ⇒ electronic catalogue of
points
plastic hammer until the compressed
circlip expands
V.A.G 1682 ⇒ Fig. 8
⇒ Fig. 15
original parts
original parts
OCTAVIA
Edition 06.05
S00.5103.68.20