Advertisement
Quick Links
ACTIVE WAND USER GUIDE
Electronic Calibration Device
© Copyright 2011–2021 Vicon Motion Systems Limited. All rights reserved. Vicon® is a registered trademark of Oxford Metrics
plc. Vicon Active Wand™ is a trademark of Oxford Metrics plc. Other product and company names herein may be the
trademarks of their respective owners. Vicon Motion Systems is an Oxford Metrics plc company.
Advertisement
Related Manuals for Vicon ACTIVE WAND
Summary of Contents for Vicon ACTIVE WAND
- Page 1 © Copyright 2011–2021 Vicon Motion Systems Limited. All rights reserved. Vicon® is a registered trademark of Oxford Metrics plc. Vicon Active Wand™ is a trademark of Oxford Metrics plc. Other product and company names herein may be the trademarks of their respective owners. Vicon Motion Systems is an Oxford Metrics plc company.
- Page 2 Introducing the Active Wand The Vicon Active Wand is an electronic motion capture calibration device that contains five pairs of LEDs. The Active Wand is used to calibrate both optical and reference video cameras. As some reference video cameras don't have strobes, the LEDs in the Active Wand make it easier to identify and locate markers from the reference video camera images.
- Page 3 If you are using a small or sunken force Active Wand level screws plate, to enable the Active Wand to lie level you may need to change the position of the pivot Tripod attachment...
- Page 4 Replace the Active Wand handle and screws. Note To order additional batteries, contact Turn on the Active Wand, run it in Continuous sales@vicon.com mode until the battery is flat, then fully recharge Due to current shipping regulations, which do not . ...
- Page 5 Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Vicon Motion Systems Ltd is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment.
- Page 6 Vicon Motion Systems Ltd is a manufacturer of electronic hardware. We are therefore considered a "downstream user" as far as the REACH document is concerned. Vicon Motion Systems Ltd is therefore not obligated to register with the European Agency for Chemicals 'ECHA'.
-
Page 7: Declaration Of Conformity
Unit 6, Oxford Industrial Park Mead Road, Yarnton, Oxford, OX5 1QU declare that the active calibration wand as part of a Vicon Gait Analysis System manufactured by VICON MOTION SYSTEMS LIMITED in that the Quality Management System has been approved by BSI Assurance UK Ltd for the manufacture and support of the aforementioned CLASS 1 Medical device. ... - Page 8 CO 80112, USA CA 90232, USA OX5 1QU, United Kingdom T: 303.799.8686 T: 310.437.4499 T: +44.1865.261800 F: 303.799.8690 support@vicon.com support@vicon.com support@vicon.com © Copyright 2021 Vicon Motion Systems. All rights reserved. Vicon trademarks https://www.vicon.com/support mailto:support@vicon.com mailto:support@vicon.com mailto:support@vicon.com https://www.vicon.com/trademarks/ Page 8 Active Wand v2...
Need help?
Do you have a question about the ACTIVE WAND and is the answer not in the manual?
Questions and answers