Removing The Palm Rest - Dell Studio 1569 Service Manual

Back to Contents Page
Palm Rest
Dell™ Studio™ 1569 Service Manual
Removing the Palm Rest
Replacing the Palm Rest
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Removing the Palm Rest
1. Follow the procedures in Before You
2. Remove the battery (see Removing the
3. Remove the power button panel (see
4. Remove the keyboard (see
5. Close the computer and turn it over.
6. Remove the seven screws that secure the palm rest to the computer base.
7. Turn the computer over and open the display as far as possible.
8. Lift the connector latch, then pull the pull-tab and disconnect the touch pad cable from the system board connector.
9. Remove the six screws that secure the palm rest to the computer base.
10. Make a note of the speaker cable routing and carefully dislodge the cable from the routing guides on the palm rest.
Begin.
Battery).
Removing the Power Button
Removing the Keyboard).
Removing the
Panel).
Battery) before working inside the