Drive Motor Replacement - Landice M1 Service Manual

Hide thumbs Also See for M1:

Table of Contents

Drive Motor Replacement

TOOLS NEEDED:

3mm and 4mm Allen Head Wrench

●

Removing the Motor Cover

UNPLUG UNIT BEFORE STARTING

Begin by folding then leaning the

treadmill up against a surface for easy

access to the motor cover. Using a 3mm

Allen Wrench, you will remove 11 bolts

in total: 7 on the bottom of the pan, and 2

on each wheel. Remove wheel plate on

each side, allowing you to remove the

cover.

Using a 4mm Allen Wrench, remove the 4 bolts keeping the wheel and drive belt pulley in place. (Fig A)

Remove the wheel plate from the unit. (Fig B) Then, carefully work the drive belt off the drive motor. (Fig C)

Using a 4mm Allen Wrench, remove the 4 remaining bolts from the drive motor.(Fig A)

Remove the black and red wires from the lower circuit board. (Fig B)

Now you can remove the drive motor. Reverse the directions to install.

1 800 - LANDICE | SERVICE@LANDICE.COM | WWW.LANDICE.COM

Table of Contents