Functions And Settings; Operation; Basic - ProLights LASERCOMBY User Manual

Combo laser effect with laser+led source
Table of Contents

Advertisement

Available languages

Available languages

- 3 - FUNCTIONS AND SETTINGS

3.1 OPERATION

Connect the supplied main cable to a socket (230 V~/50 Hz). Switch on the LASERCOMBY with the mains
switch (13). To switch on the laser beam, connect the supplied key to the lock of the switch (9) and turn
the key to position ON. When laser is powered on, LED monitor on rear panel shows the current operating
mode. Then the unit is ready for operation and can be operated via a DMX controller or it independently
performs its show program in succession.
WARNING - This laser corresponds to the class 3B. Do not permit operation by persons not qualified for
operating the device.
Laser will be output from laser aperture in 5 seconds after the unit is powered on.
• Regular breaks during operation are essential to maximize the life of this device as it is not designed
for continual use.
• Do not switch the unit on and off in short time intervals.
• Always unplug the unit when it is not used for a longer time.
• In the event of serious operation problems, stop using the fixture and contact the manufacturer di-
rectly.

3.2 BASIC

Access control panel functions using the four panel buttons located directly underneath the LED Display
(fig.5).
MENU
Press to find an operation
mode or to back out of the
current menu option
LASERCOMBY
UP
Press to scroll up the list of
options or to find a higher
value
DOWN
Press to scroll down the list
of options or to find a lower
value
Fig.5
ENTER
Press to activate a menu
option or a selected value
9

Advertisement

Chapters

Table of Contents
loading

Table of Contents