Current And Voltage Measurements Using Two Current/ Voltage Converters On A Single Portable Measuring Instrument - Parker SCMA-VADC-600 Operating Instructions Manual

.4 Current and voltage measurements using two current/volt-
age converters on a single portable measuring instrument
In order to measure the current and voltage on a consumer load, you
need to use two current/voltage converters connected to one portable
measuring instrument. Both sensor connection cables are connected to
the load according to the graphic below. The cable colour indicates to
which measuring point the sensor cable should be connected.
NOTICE
Be sure that the current measurement is led back to the earth
wire (ground). Also check that both earth wires (black) from the
sensor cables are on the same potential voltage.
0