The Module Specific Screen - Cabletron Systems Environmental Module TM 9C300-1 User Manual

The Module Specific Screen
Select a module on the Module Selection Screen, as shown in Figure 3-23, to
display configuration information on the Module Specific Screen, as shown in
Figure 3-24.
Line 1 identifies the selected module by chassis slot location, current status, and
hardware revision. A module's status can be one of the following:
ON-LINE
DOWN
FAULT
Lines 2 and 3 display a firmware revision and SMB-1 firmware revision, along
with the BOOT PROM revision and the module serial number.
Line 4 lists the following three submenus. Access a specific submenu by selecting
it on the screen.
<ENV>
<MEMORY>
<BACKPLANE>
Select <EXIT> to return to the Module Selection Screen.
The host processor is operational.
The host processor is not operational.
The power-up diagnostic tests have failed.
accesses the Module Environment Screen, showing
environmental parameters for the selected module.
accesses the Module Memory Screen, showing the amount of
various memory categories on the module.
accesses the Module Backplane Screen, showing backplane
configuration parameters.
MODULE xx STATUS ON-LINE HW REV xxx
FW REV x.xx.xx SMB 1 FW REV x.xx.xx
BOOT PROM REV x.xx.xx SN xxxxxxxxxxxx
<ENV> <MEMORY> <BACKPLANE> <EXIT>
Figure 3-24. The Module Specific Screen
Interactive Mode
3-19