The Bbu Screen; The Module Selection Screen - Cabletron Systems Environmental Module TM 9C300-1 User Manual

9C300-1 Environmental Module Operation

The BBU Screen

Select <BBU> from the System Screen, as shown in Figure 3-15, to view the status
of the Battery Backup Units (BBUs). Figure 3-22 shows the BBU Screen.
Line 1 displays the screen heading.
Line 2 displays BBU status (CHARGING, STANDBY or DISCHARGING) if BBUs
are installed; however, if no BBUs are installed, the message NO BBU
INSTALLED displays.
Line 3 displays the estimated amount of system run time stored in the BBUs if the
system is running on a standard power source; or, if the system is running on
BBUs, the amount of system run time remaining in the BBUs at the current power
load.
Select <EXIT> to return to the System Screen.

The Module Selection Screen

Select <MODULES> from the Main Screen, as shown in Figure 3-13, to display
the chassis slot locations in which modules have been installed.
Line 1, as shown in Figure 3-23, displays the screen heading.
Lines 2 and 3 list all modules in the MMAC-Plus by slot number.
Select <EXIT> to return to the main System Screen.
3-18
BATTERY STATUS
BBU CHARGING
SYSTEM RUN TIME AT PWR LOSS xxx MINUTES
Figure 3-22. The BBU Screen
MODULE SELECTION
<EM> <1> <2> <3> <4> <5> <6> <7>
<8> <9> <10> <11> <12> <13> <14>
Figure 3-23. The Module Selection Screen
<EXIT>
<EXIT>