Table of Contents
Advertisement
Connecting to a Wi-Fi Network at the Control Panel
To connect to a Wi-Fi network at the control panel:
1. At the printer control panel, press the Home button.
2. Log in as administrator. For details, refer to the System Administrator Guide at
office/VLC71XXdocs.
3. Touch Device > Connectivity > Wi-Fi.
4. To enable the Wi-Fi feature, touch the enable toggle button.
5. To connect automatically to an existing Wi-Fi network:
a. In the list of available Wi-Fi networks, touch the required network.
If the required Wi-Fi network is not listed, or if the required network uses WPS, configure the
connection manually. For details, go to the next step.
b. If needed, to log in to the network, type the password.
c. To select a Wi-Fi frequency band, touch Wi-Fi Band, then select an option.
By default, the Wi-Fi frequency band is set to AUTO.
d. Touch OK.
6. To connect manually to a Wi-Fi Network:
a. Touch Manual Setup.
b. In the first field, type a name for the Wi-Fi network, then touch Enter.
c. Touch Network Type, then select an option.
d. Touch Security, then select an option.
e. Touch Wi-Fi Protected Setup (WPS), then select an option.
Note:
f. Touch OK.
Configuring the Primary Network at the Control Panel
You can set the primary network connection type at the device control panel.
• A Primary Network setup is required only if the optional Wi-Fi network connection kit is installed
and enabled.
• By default, without a Wi-Fi network connection, the primary network is set to Ethernet. When the
kit is installed and enabled, the device acquires two network connections. One network connection
is primary, and the other network connection is secondary.
For a WPS setup with a Push Button Connection (PBC), select PBC.
www.xerox.com/
69
Advertisement
Table of Contents
