Replacing The Battery - Delta DE212 GLOBAL Operation And Installation Manual

R
EPLACING THE BATTERY
Note:
The battery module 02465 and all replaceable parts of the transmitter, must be original parts delivered
by Delta RC AS. Otherwise the Ex certifications are lost, and the customer has to take all responsibilities. The
operator is only allowed to change the battery module, nothing else.
From December 2013, the battery module is changed, in accordance with the IECEx certification. The new
battery module for IECEx is 02465.
NOTE: Battery module 02465, cannot be replaced by the old 02166, but 02465 can replace the old 02166. Old
02166 battery modules are no longer valid for replacement and must be discarded.
T
HE BATTERY REPLACEMENT OPERATION MUST ALWAYS TAKE PLACE OUTSIDE
When the battery module has to be replaced, this procedure needs to be followed strictly:
•
Verify that the old battery module 02166 is replaced by 02465.
Battery module 02465 must be replaced by 02465 only.
•
Battery types other than specified must NEVER be used.
•
Open the bottom end of the transmitter, by pressing the two lock-sections in.
•
Pull the battery module gently out of the housing without jamming the O-ring.
•
Disconnect the battery from connector marked "P3" on the PCB, by lifting the connector up.
See section 5.3.2
•
Put a thin layer of non-corrosive, acid-free Vaseline on the new battery module O-ring
•
Connect the new battery, and push the battery module back into the housing. Carefully make
sure the O-ring and connecting wires are not jammed during this operation.
•
When the operation is finished, charge the battery for 3 hours, and test all functions.
See section 3.4
•
Defective batteries must be disposed at a proper recycling facility.
Please refer to chapter 8 for further information.
D RC AS
ELTA
User and Installation Manual, DE212 GLOBAL
WARNING:
E - .
X AREA
Page 15 of 36
Document 02743