Vittorazi Motors Moster 185 Plus Maintenance Manual page 30

Replace the gaskets (5) and the O-ring (3).
Place the following components on the carburettor flange (7): gasket (5), spacer (6), gasket (5).
Position the carburettor (4).
Insert the O-ring (3) into the airbox connector (2), taking care not to pull it out of the housing.
Insert the 2 Allen screws M6x60 (1) with threadlocker (recommended Loxeal 55-03/Loctite 243) in
the connector of the airbox (2), screw progressively, then tighten with the torque shown in the
figure.
Moster 185 Plus - Maintenance manual - V1
6 Nm
30