Operation - Scilogex SCI100VC Operating Instructions Manual

3.2 Operation

3.2.1 Instrument preparation
•
The instrument should be place on a stable surface and well ventilated without any
flammables or explosives.
•
Ensure that the label indicated the correct voltage before connecting the device to
power supply.
•
Ensure that the power socket is grounded properly.
•
Connects the lines of the instrument, vacuum pump and load properly.
•
Connects the power cable of the vacuum pump to the instrument and turn ON the
vacuum pump switch.
•
Connect the power cable of the instrument properly, and turn ON the Power switch.
3.2.2. Startup interface description
Button name
VENT
PROGRAM
SETTINGS
START
Fig. 3.2.1
Function introduction
Gently touch VENT to vent air and lift it to stop
venting.
Choose the control mode and set the control pressure
value and running time.
Set the delay time to open and close the pump and
valve, set the local atmospheric pressure, adjust the
pressure sensor calibration parameters.
Gently touch it to start the control program, with the
5