Table of Contents
Advertisement
3.2.4. Operation mode selection and configuration
1
.
Click the "Program" button to pop up the program selection interface as shown in the
following figure.
Click "Vacuum control" in the "Function" section to choose the
single-point control operation mode, click "Program" to select the
program operation mode.
2. Single-point control operation mode
Click "Vacuum control" in the "Function" section to refresh the current
page as shown in the following figure.
Fig. 3.2.3
Fig. 3.2.4
8
Advertisement
Table of Contents
Need help?
Do you have a question about the SCI100VC and is the answer not in the manual?