Preparing Your Computer To Access The Web Configurator; Static Ip Configuration In Microsoft Windows - ZyXEL Communications WAP6807 User Manual

The following table describes the sub-menus.
Table 21 Navigation Panel (Repeater/AP Mode)
LINK
Status
Overview
System Log
System
Time
Password
Restore /
Firmware
Upgrade
Restart
Wireless
WiFi
Configuration
5.4 Preparing Your Computer to Access the Web
Configurator
This section shows you how to assign a static IP address to your computer.
Your computer needs to be in the same subnet as the WAP6807 in order to access the Web
Configurator. Below you will find the steps to set a static IP on both Windows 7
and MAC OS X 10.11

5.4.1 Static IP Configuration in Microsoft Windows

Follow these steps to change your computer's IP address in Windows 7 operating system.
Click the Network Icon
1
a small message window will appear, select Open Network and Sharing Center.
Chapter 5 Web Configurator
TAB FUNCTION
Overview Use this screen to view the WAP6807's basic information, such as firmware
version or work mode.
System Log Use this screen to view the status of events that occurred to the WAP6807.
Time Use this screen to change the WAP6807's time and date.
Password Use this screen to change user password on the WAP6807.
Restore / Use this screen to backup and restore the WAP6807's configuration (settings)
Firmware or reset the factory default settings.
Upgrade
Use this screen to upload firmware to the WAP6807.
Restart Use this screen to restart the WAP6807 without turning the power off.
WiFi Use this screen to configure the WiFi settings and WLAN authentication/
Configuration security settings.
(Section 5.4.2 on page
located in the System Tray of your Task Bar. After you have clicked the icon
WAP6807 User's Guide
53) operating systems.
51
(Section 5.4.1 on page 51)