ZyXEL Communications WAP6807 Quick Start Manual

WAP6807
Gigabit Wireless Extender
Quick Start Guide
Positioning the WAP6807
1
Room 1
Router
2
Bottom view
Set up using the Ethernet cable - Recommended
Router
Set up using the WPS button
1
WPS
Router
3
WAP6807
4
Device
SSID: DH_XXXXXX
Label
Wireless key:
1/1
Room 2
Need WiFi here
WAP6807 Clients
3
Wait until the power LED
turns steady green
Rear Panel
WAP6807
2
within
2
minutes
WAP6807
WiFi
DH_XXXXXX
Connect
XXXXXXXXXX
Router
Package Contents
Device Power Adapter
If you need any assistance please call us on 0333 0155156 or
email help@digitalhomeuk.com
Positioning the WAP6807
1. Place the WAP6807 between your router and where you want to extend your
wireless network.
Note: The WAP6807 requires a good wireless connection back to the main router as
indicated by a green LINK status LED. See set up below.
Powering up the WAP6807
2. Rotate the stand on the bottom of the WAP6807 90 degrees.
3. Plug in the power adapter and turn on the WAP6807.
Wait for about 2 minutes. The Power LED lights up steady green.
Use the second ethernet cable provided to connect one of the yellow LAN ports on the
main router to one of the yellow LAN ports on the WAP 6807.
Power on the WAP 6807. This will automatically pair the extender with the main router
and download the correct MPro Mesh configuration.
During the set up the POWER and LINK LEDs blink amber to indicate the pairing is in
process.
The WAP6807 LINK and POWER LEDs light up solid green if the connection is
successful.
The WAP 6807 can now be unplugged (from the power and ethernet cables) and moved
to a location where the extended WiFi signal is required (connecting the power cable at
the required location).
Note: The WAP 6807 requires a good wireless connection back to the main router as
indicated by a green LINK status LED. If there is no LINK light then the WAP 6807 needs
to be moved closer to the main router.
Press the WPS button on the Zyxel MPro Mesh Router. Release it when the Zyxel MPro Mesh
1
Router WPS
2 Press the WPS button on the WAP6807 once and release it. The POWER
LEDs blink amber indicate the pairing is in process.
3 The WAP6807 LINK
WPS
On your smartphone or wireless client, find the Zyxel MPro Mesh Router SSID. Enter the
4
Zyxel MPro Mesh Router wireless key to connect.
Note: The POWER
WiFi network. The LINK
status. See the LED table.
Power
Link
Ethernet Cable Quick Start Declaration of
Guide
Safety Warnings
www.digitalhomeuk.com
LED blinks.
and POWER LEDs light up green if the connection is successful.
LED on the WAP6807 indicates if the WAP6807 is ready to join the
LED on the WAP6807 indicates WiFi link quality and WPS pairing
Green On - Device ready in Repeater mode.
Blinking - Device booting. Please wait.
Amber On - Device ready in AP mode.
Blinking - Device joining WiFi network. Please wait.
Red On - Device failed to join the WiFi network.
Off - Device is not receiving power.
Green On - Good WiFi connection to the router.
On - Signal is too strong. Move the WAP6807 away from the router.
Amber
Blinking - Connecting to the router. Please wait.
On - Signal is too weak. Move the WAP6807 closer to the router
Red
Off - No connection.
DoC
Conformity
and LINK