Table of Contents
Advertisement
Available languages
Available languages
Softer materials require greater speed than harder
materials. See right speadsheet for recommended speeds
for the workpiece material.
FIG.24
1
Mechanical variable speed (Fig. 24)
This is a variable speed bench drill press. To increase or
FOR YOUR OWN SAFETY, TURN
THE SWITCH OFF AND REMOVE THE PLUG FROM
THE POWER SUPPLY BEFORE MAINTAINING OR
LUBRICATING THE BENCH DRILL PRESS.
Vacuum sawdust or metal shavings that accumulates in
and on the motor, pulley housing, table, and work surface.
Apply a light coat of paste wax to the column and table to
help keep these surfaces clean and rust-free.
The ball bearings in the spindle and the V-belt pulley
decrease the speed when operating, raise or lower the
speed handle (1).
Use the following table to determine the recommended
speed for the drill size you are using and the type of
material you are to drill. While drilling, check the speed on
the digital speed readout (2) located at the front of the drill
2
press.
Recommended Speed for Dill Size & Material
SPEED RANDE
(R.P.M.)
2000-2500
1400-2000
1000-1400
800-1000
450-800
MAINTENANCE
assembly are greased and permanently sealed. Pull the
spindle down and oil the spindle sleeve moderately every
three months.
Lubricate the table bracket and locking knobs if they
become difficult to use.
should be performed by a qualified service technician.
33
ALUM ZINC
WOOD
BRASS
in
mm
in
mm
3/8
9.5
7/32
5.6
5/8
16.0
11/32
8.75
7/8
22.0
15/32
12.0
1-1/4
31.75
11/16
17.5
1-5/8
41.4
3/4
19.0
All servicing of the drill press
IRON STEEL
in
mm
3/32
2.4
5/32
4.0
1/4
6.4
3/8
9.5
5/8
16.0
Advertisement
Table of Contents
