Promac 212VLL Operator's Manual page 29

Drill press head to column (Fig. 5)
The drill press head is heavy. To
avoid injury, two people should lift it into position.
1. Carefully lift the drill press head assembly (1) and
position it over the column (2).
2. Place the mounting opening (3) on the drill press
head over the top of the column.
Ensure the drill press head is seated properly on the
column.
3. Align the direction of the drill press head with the
direction of the base and the table.
4. Tighten the set screw (4) using a hex key.
FIG.6
Feed handles (Fig. 6)
1. Insert the three feed handles (1) into the threaded
openings on the feed hub (2).
2. Manually tighten handles into openings. Note: When
using the bench drill press, one or two of the feed handles
may be removed if an unusually-shaped workpiece
interferes with handle rotation.
FIG.7
1
1
2
2
Speed handle (Fig. 7)
1. Insert the feed handle (1) into the threaded opening
on the speed hub (2).
2. Manually tighten handle into opening.
FIG.8
Mount the bench drill press (Fig. 8)
The bench drill press must be securely fastened through
the mounting holes (1) to a stand or workbench with
heavy-duty fasteners. This will prevent the bench drill
press from tipping over, sliding, or walking during
operation.
IMPORTANT: If the stand or workbench has a tendency
to move during operation, fasten the workbench securely
to the floor.
FIG.9
LED bulb (Fig. 9)
Insert the LED bulb (1) into the socket (2) in the motor
head assembly.
Note: LED bulb can be replaced by any 230V 8L LED bulb
if the original one runs out of its lifetime. Install the
replacement LED bulb the same way you install the
original one.
27
1
2
1