Table of Contents
Advertisement
Available languages
Available languages
the drill press may make some readjustments necessary.
FIG.17
4
FIG.18
Laser line (Fig. 17 and 18)
DO NOT STARE DIRECTLY AT
THE LASER BEAM! A HAZARD MAY EXIST IF YOU
DELIBERATELY STARE INTO THE BEAM, PLEASE
OBSERVE ALL SAFETY RULES: THE LASER SHALL
BE USED AND MAINTAINED IN ACCORDANCE WITH
THE MANUFACTURER'S INSTRUCTIONS:
NEVER AIM THE BEAM AT ANY PERSON OR
•
AN OBJECT OTHER THAN THE WORKPIECE.
DO NOT PROJECT THE LASER BEAM
•
INTO THE EYES OF OTHERS.
ALWAYS ENSURE THE LASER BEAM IS AIMED
•
AT A WORKPIECE THAT DOES NOT POSSESS
REFLECTIVE SURFACES AS THE LASER BEAM
COULD BE PROJECTED INTO YOUR EYES OR THE
EYES OF OTHERS.
1.
Place a workpiece on the table.
2.
Turn the laser switch (1) to the ON position.
3.
Lower the drill bit to meet the workpiece (2). The two
1
3
30
laser lines should cross where the drill meets the
workpiece.
4.
If the laser needs to be adjusted:
a.
Using a 3 mm hex key, turn the laser adjustment set
screws (3) counter-clockwise.
b.
Rotate the laser light housing (4) until the two laser
lines intersect where the drill meets the workpiece. DO
NOT stare directly at the laser lines.
5. Re-tighten the adjustment set screws (3).
FIG.19
Spindle return spring (Fig. 19)
The spindle is equipped with an auto-return mechanism.
The main components are a spring and a notched housing.
The spring was properly adjusted at the factory and should
not be readjusted unless absolutely necessary.
1.
Unplug the drill press.
2.
Place a screwdriver into the loop (1) to hold the
spring in place.
3.
Loosen
the two housing
approximately
1/4" (6 mm). Do not remove the nuts from the threaded
shaft. Do not allow the spring 3 or spring housing to slip
out of control.
4.
While firmly holding the spring housing (3), carefully
pull the spring housing out until it clears the raised notch
(4).
5.
Turn the housing so that the next notch (5) is
engaged with the raised notch (4).
To increase the spindle return tension, turn the
•
spring housing counter-clockwise.
To decrease the tension, turn the spring housing
•
clockwise.
6.
Tighten the two housing nuts. Do not overtighten the
two nuts. If the nuts are tightened too much, the movement
nuts (2)
Advertisement
Table of Contents
