Table of Contents
Advertisement
Available languages
Available languages
YOUR HEALTH. ALWAYS OPERATE THE DRILL
PRESS IN A WELL-VENTILATED AREA. USE DUST
COLLECTION SYSTEMS WHENEVER POSSIBLE.
ALWAYS WEAR EYE PROTECTION
A bench drill press can throw foreign objects into the eyes
which could cause permanent eye damage.
ALWAYS wear safety goggles (not glasses). Ordinary
eyeglasses have only impact-resistant lenses...they are
NOT safety glasses.
LASER SAFETY
The laser light beam used in this system is Class III. These
lasers do not normally present an optical hazard, although
staring at the beam may cause flash blindness.
DO NOT STARE DIRECTLY AT
THE LASER BEAM! A HAZARD MAY EXIST IF YOU
DELIBERATELY STARE INTO THE BEAM, PLEASE
OBSERVE ALL SAFETY RULES AS FOLLOWS:
•
THE LASER SHALL BE USED AND MAINTAINED
IN ACCORDANCE WITH THE MANUFACTURER'S
INSTRUCTIONS.
•
NEVER AIM THE BEAM AT ANY PERSON OR
AN OBJECT OTHER THAN THE WORKPIECE.
•
DO NOT PROJECT THE LASER BEAM
INTO THE EYES OF OTHERS.
•
ALWAYS ENSURE THE LASER BEAM IS AIMED
AT A WORKPIECE THAT DOES NOT POSSESS
REFLECTIVE SURFACES, AS THE LASER BEAM
COULD BE PROJECTED INTO YOUR EYES OR THE
EYES OF OTHERS.
SPECIFIC SAFETY RULES FOR BENCH
DRILL PRESSES
DO NOT OPERATE YOUR BENCH
DRILL
PRESS
UNTIL
ASSEMBLED AND INSTALLED ACCORDING TO THE
IT
IS
COMPLETELY
INSTRUCTIONS.
1.
NEVER TURN THE BENCH DRILL PRESS ON until
the table is clear of all foreign objects (tools, scraps, etc.).
2.
ALWAYS KEEP hands and fingers away from the
drill bit.
3.
DO NOT drill materials that do not have a flat
surface—unless a suitable support is used (clamp or vise).
4.
NEVER start the drill press with the drill bit pressed
against the work piece.
5.
MAKE SURE the table lock is tightened before
starting the bench drill press.
6.
NEVER layout, assemble, or set-up any work on the
table while the drill is ON.
7.
MAKE SURE drill bit is securely locked in the chuck.
8.
MAKE SURE chuck key is removed from the chuck
before turning power ON.
9.
ADJUST the table or depth stop to avoid drilling into
the table.
10. ALWAYS stop the drill before removing scrap pieces
from the table.
11. USE CLAMPS or a vise to secure a work piece to the
table. This will prevent the work piece from rotating with
the drill bit.
12. DO NOT wear gloves when operating a drill press.
13. BEFORE LEAVING THE MACHINE, SHUT THE
POWER OFF, remove the drill bit and clean the table.
14. SET THE DRILL PRESS to the speed that is
appropriate for the material being drilled.
15. SHOULD any part of your bench drill press be
missing, damaged, or any electrical component fail to
perform properly, shut the power OFF and unplug the drill
press. Replace missing, damaged, or failed parts before
resuming operation.
ELECTRICAL REQUIREMENTS
POWER SUPPLY AND MOTOR
SPECIFICATIONS
hazards, or damage to the tool, use proper circuit
protection. Use a separate electrical circuit for your tools.
To avoid shock or fire, if power cord is worn or cut, or
damaged in any way, have it replaced immediately.
GROUNDING INSTRUCTIONS
22
To avoid electrical hazards, fire
Advertisement
Table of Contents
