Advertisement
PHASE 1 – PREPARATION
1.1 REMOVING
PHASE 2 – INSTALLATION
2.1 SEAT COVER INSTALLATION
2.1 Install Seat Back Cover.
q
q Ensure the tag inside the cover corresponds with the seat you are working on.
Each cover will have a Driver or Passenger tag.
q Turn seat cover 3/4 of the way inside out.
q Pull seat back cover into position, making sure that the holes in the cover align
with the holes in the seat back.
q Stretch the cover over the headrest holes.
q Continue pulling the cover down the seat back, turning it right side out as you go.
q Push flap from front of cover between seat back and seat bottom, out the back of the seat .
q Double the end of the flap over to prevent the "hook" Velcro
from sticking to the factory upholstery.
q Pull the flap tight and attach to the Velcro on the back of the seat.
q Fasten flap under the armrest.
For technical support, contact us at 1-800-565-5321
1.1 Remove Headrests.
q
q Pull headrests out of the seats
by pressing the tabs at the base of the headreasts.
q Slide seat forward, raise up, and lean seat back forward.
6257-19 Installation Guide | REV. A1 | Page 3
Advertisement
