Viewing Port Status Information; Viewing And Changing Ip-Related Information - IBM 8271 Nways F12 User Manual

5-8 C 5: W
HAPTER ORKING
Viewing Port Status
Information
Viewing and
Changing IP-related
Information
W C L
ITH THE OMMAND INE
You can view information about the status of Ethernet ports on the
Switch using the summary command on the Ethernet menu.
To view the port status information:
1 At the Top-level menu, enter:
ethernet summary
The following prompt is displayed:
Select Ethernet port (1-24|all):
For the Model F12/F24, ports 1 to 24 are the 10BASE-T/100BASE-TX
ports. Any additional ports provided through an Expansion Module are
numbered 25 and onwards.
2 Enter the number of a port, or enter all for all the ports.
The port status information for the port(s) is displayed.
An example of the port status information is shown below:
Port State
1 Enabled
2 Disabled
3 Enabled
...
24 Enabled
The statistics that are displayed are gathered in the time interval since
the last reset, initialization or power-off/on cycle.
You can view and change IP-related information for the current Switch
unit in the stack using the commands on the IP menu. These
commands allow you to:
Specify the IP and SLIP information for the Switch
Display the IP information for the Switch
Specify whether the Switch uses BOOTP
PING other devices on your network
To view and change IP-related information for another Switch unit in
the stack, you need to select that unit using the unit command. For
more information, see "Moving the Focus of the Command Line
Interface" on page 5-12.
I
NTERFACE
Rx Packets
163542
0
639263
645232
Rx Octets Errors
65439864 4
0 0
83636219 4
23142514 0