IBM 8271 Nways F12 User Manual page 176

B-2 A B: U
PPENDIX SING THE
S W U
ERIAL EB TILITY
3 Select Run from the Start menu.
4 In the Run dialog box, type
(where is the letter of your CD-ROM drive) and click OK.
drive
The installation program starts and checks your system configuration;
enter any information that is requested.
If the setup program cannot find specific files on your management
workstation, it asks you to insert your Windows 95 CD-ROM. If it still
cannot find the files, you must obtain them directly from Microsoft.
Contact Microsoft for more information.
5 When the installation program has ensured all the relevant files are
installed, it asks you to select a COM port. This is the serial port on
your management workstation that you want to use when connecting
to the console port of the Switch.
If you click Advanced, the Advanced Configuration Parameters dialog
box is displayed, showing all the settings that the Serial Web Utility
uses when it is running. These default settings are already correct for
connection to the Switch, so you should not need to change them:
Connection name
Allows you to enter a name for the connection.
Modem name
Allows you to enter a name for the modem connection.
PC SLIP Address
Displays the SLIP address that is to be allocated to the management
workstation. The default address is 192.168.101.2.
Device URL
Displays the URL that the Serial Web Utility uses to access the Switch,
which includes the SLIP address for the Switch. For example, the
default SLIP address for the Switch is 192.168.101.1 so the URL is:
http://192.168.101.1/
Flow Control None / XON/XOFF / Hardware RTS/CTS
Allows you to specify the serial line flow control that the management
workstation uses.
Data bits, Stop bits and Parity are all fixed.
Speed 1200 / 2400 / 4800 / 9600 / 19200
Allows you to specify the line speed (baud rate) that the management
workstation uses.
drive :\Win95\Drivers\Slip\SETUP