Fc Port Status Led; Qsfp Port Status Led - IBM 8960-F64 Hardware Installation Manual

FC port status LED

Refer to the following table to interpret the FC port status LEDs.
TABLE 11 SFP+ FC port status LED patterns during normal operation
LED color
No light
Steady green
Slow-flashing green (on 1/2 second;
then off 1/2 second)
Fast-flashing green (on 1/4 second;
then off 1/4 second)
Flickering green
Steady amber
Slow-flashing amber (on 2 seconds;
then off 2 seconds)
Fast-flashing amber (on 1/2 second;
then off 1/2 second)

QSFP port status LED

Refer to the following table to interpret the QSFP port status LEDs
Hardware Installation Guide
Status of hardware
Indicates one of the following:
• No signal or light carrier (media or
cable) detected.
• Device may be currently
initializing.
• Connected device is configured in
an offline state.
Port is online (connected to external
device) but has no traffic.
Port is online but segmented
because of a loopback cable or
incompatible device connection.
Port is online and an internal
loopback diagnostic test is running.
Port is online and frames are flowing
through the port.
Port is receiving light or signal
carrier, but it is not online yet.
Port is disabled because of
diagnostics or the portDisable
command.
SFP+ or port is faulty.
FC port status LED
Recommended action
• Verify the power LED is on, and
check the SFP+ and cable.
• Verify the device is not currently
being initialized.
• Verify the status of the connected
device.
No action required.
Verify that the correct device is
attached to the switch.
No action required.
No action required.
No action required.
Reset the port.
The portCfgPersistentDisable
command is persistent across
reboots.
Reset the port.
Replace the SFP+. Must be a
Brocade-branded SFP+.
69