IBM 8271 Nways F12 User Manual page 64

4-4 C 4: W
HAPTER ORKING
About The Getting
Started Pages
W W I
ITH THE EB NTERFACE
When you access the web interface for the first time or after a
power-off/on cycle, a set of Getting Started pages are displayed. The
first Getting Started page, Getting Started - Introduction is shown in
Figure 4-2.
The Getting Started - Introduction page
Figure 4-2
The Getting Started pages allow you to enter basic setup information
for the stack. As you go through the pages, you are asked to enter:
1 A descriptive name for the stack.
2 Whether you want to allocate IP information for the stack, or whether
you want a BOOTP server (if you have one) to allocate the information
automatically.
If you choose to allocate IP information yourself, you are prompted to
enter the following information:
An IP address for the stack. For more information about IP
addresses, see "Managing the Stack Over the Network" on
page 3-7.
A subnet mask for the stack. For more information about subnet
masks, see "Subnets and Using a Subnet Mask" on page 3-8.
An IP address for the default router, if one exists on your network.