Displaying
Configuration
Information About
the Current Switch
Viewing and Changing Information About the Stack
Returning the Focus to the Previous Switch Unit
You can return the focus of the command line interface to the previous
Switch unit in the stack using the logout command on the System
menu.
You can display configuration information about the current Switch unit
in the stack using the display command on the System menu. This
information may be useful for your technical support representative if
you have a problem.
To display the information:
From the top-level menu, enter:
system display
The configuration information is displayed.
An example of the information is shown below:
IBM 8271 Nways Ethernet Switch Model F24
Unit Name: Development
Location: Wiring closet, Floor 2
Contact: Edward Monk
Time since reset: 2 days, 3 hours, 10 minutes
Operational Version: 1.00
Hardware Version: 1.00
Serial Number: 2103332
The configuration information contains the following read-only fields:
Unit Name
Displays the descriptive name, or system name, for the unit. For
information about assigning a new name, see "Specifying a Descriptive
Name for the Stack" on page 4-21.
Location
Displays the physical location of the unit. For information about
assigning a new location, see "Specifying the Physical Location of the
Stack" on page 4-23.
Contact
Displays the details of a person to contact in the event of an
emergency. For information about assigning new contact details, see
"Specifying a Contact for the Stack" on page 4-25.
Boot Version: 1.00
5-13