Height Limit Setting - Using Current Highest Point - PROLEC PME100 User Manual

7.1.3 Height Limit Setting - Using Current Highest Point

Move equipment to required
height limit and press this button
To set the height limit using the
machine, move the equipment to
the desired maximum height,
and press the 'current highest
point' button. A confirmation
box will appear reporting the
height set. Press the TICK but-
ton to continue.
that the limit activates at the set point. A limit cannot be deactivated when
close to or at the limit. Observe the operational limitations given in section 4.
562100-000, Issue1.1, December 2015
Set the limit using the current highest point of the
machine. Ensure the equipment is off the ground
before setting the limit.
Once a limit is set, the internal alarm will sound and the RED LED
will light if the equipment reaches the current limit. Always check
18 of 36