Menu 4.7 Emergency Track; Emergency Track - Hardi HC5500 Instruction Book

Menu 4.7 Emergency Track

Emergency Track

When this menu is entered, the "bypass" function is active so that all
sensors are ignored. The system can be operated manually so it is
possible to fold the boom and drive home. In the menu, the sensor
voltages can be checked, which is useful for HARDI® service to solve
the problem.
F: Front potentiometer
R: Rear potentiometer
L: Lock sensor (no sensor reads 00.0 Volts)
B: Boom sensor
Lock sensor:
If the lock sensor indicates "released" (high voltage) and the track
selection switch is in either "auto" or "manual", it is possible to use the
"Left/Right steer" and "Fold inner in" switches regardless of any other
inputs the Controller receive from sensors.
If the lock sensor indicates "locked" (low voltage) and the track selec-
tion switch is in either "auto" or "manual", it is possible to use "Fold
inner in" switch regardless of any other inputs the Controller receives
from sensors. Manual or automatic tracking is not possible.
If the track selection switch is switched to "align", the trapeze lock
will attempt to lock regardless of any sensor reading. No automatic
align is attempted. Manual or automatic tracking is not possible.
Once the boom is folded into transport position, exit the menu. This
will activate the track lock if it is not damaged. As an extra security,
switch power to HC 5500 to OFF and stop oil flow to the sprayer.
DANGER! Emergency only. Don't track with the boom folded! Safety system is disabled.
ATTENTION! Note this menu is only shown if Jobcom hardware is fitted, and the software is enabled.
8 - Menu 4 Toolbox
8.3