Impact Sensor - NetPing Input+Relay R404 User Manual

[ENG] NetPing Input+Relay R404, User guide -[ENG] 7. [DKST 57]Connection of external sensors and actuators.
Colored wire
Black (general)
Red (N.C.)
White (N.O.)
Important! Sensors of the "dry contact" type: 220V presence sensor, leakage sensor and others are
connected to the INPUT lines of the device. You can connect any 16 sensors from this set.
The sensor comes with a non-detachable cable with lugs at the ends.
using cable 4 extender,
cable section of at least 0.4 mm2. The maximum permissible loop length is 100 meters.

Impact sensor

The shock sensor is connected with a four-wire line in accordance with the table:
Blue (threshold - 1)
Green (threshold - 2)
The shock sensor can be triggered at different thresholds - for this, two IN lines are used.
4m, which are connected in series into each other, or independently using any wire with a
Colored wire
Red
Black
IN1 ... IN16
The cable length can be increased by
[ENG] 7. [DKST 57]Connection of external sensors and actuators.
Terminal
GND
IN1 ... IN16
Terminal
IN1 ... IN16
IN1 ... IN16
+12V
GND
–