Table of Contents
Advertisement
[ENG] NetPing Input+Relay R404, User guide -[ENG] 7. [DKST 57]Connection of external sensors and actuators.
Important! Sensors of the "dry contact" type: 220V presence sensor, leakage sensor and others are
connected to the INPUT lines of the device. You can connect any 16 sensors from this set.
The sensor comes with a non-detachable cable with lugs at the ends.
using cable 4 extender,
cable section of at least 0.4 mm2. The maximum permissible loop length is 100 meters.
PIR detector (mod.M105-1E)
The motion sensor is connected with a four-wire line in accordance with the table:
Colored wire
Green
White
Black
Red
Important! Sensors of the "dry contact" type: 220V presence sensor, leakage sensor and others are
connected to the INPUT lines of the device. You can connect any 16 sensors from this set.
External sockets
The sensor comes with a non-detachable cable with lugs at the ends.
using cable 4 extender,
cable section of at least 0.4 mm2. The maximum permissible loop length is 100 meters.
The number of connected
When connecting the outlet to the device, all wires are involved, except for the brown (white) one. When the state is
"log. 0 "on the OUT line at the socket there will be 220 V - the load will be turned on. When the state is "log. 1 "on the
OUT line, the socket will be de-energized, the load will be disconnected.
Important!
The brown (white) wire is not used and must remain unconnected!
OUT line control:
Colored wire
Red
Black
Blue (green)
RELAYS control (NO - normally open contact, NC - normally closed contact):
4m, which are connected in series into each other, or independently using any wire with a
The first wire after the marked
The second wire after the marked
Third wire after marked
NetPing AC/DIN
4m, which are connected in series into each other, or independently using any wire with a
NetPing AC / DIN sockets
+5V
GND
One of the OUT lines - 1 - 4 (in the "output" mode, log. 1)
The cable length can be increased by
Flat wire
Marked (red) wire
The cable length can be increased by
is limited only by the number of free OUT and RELAYS lines.
[ENG] 7. [DKST 57]Connection of external sensors and actuators.
Terminal
IN1 ... IN16
GND
GND
+12V
Terminal
–
Advertisement
Table of Contents
