NetPing Input+Relay R404 User Manual page 15

Indicator CPU on the ETH1
Relays indicators
Socket 1W
Socet RS485/RS232
Indicator PWR
Reset
Device from the sides of connection of
external devices
BAT
DC12V
+5В
+12В
GND
DAC
Relays
IN 1..16
[ENG] NetPing Input+Relay R404, User guide -[ENG] 5. [DKST 57]Sockets and Indication Elements
Device operation indicator:
• continuously lit if the device is powered;
• blinks 5-6 times when the device is turned on (during the
firmware download process);
• blinks 15-20 times when the device parameters are reset to
default values;
• flashes periodically when the device sends packets to the
Ethernet network;
• flashes intensively, indicating the device software update
mode.
The indicators light up when the electromechanical relay is
activated, signaling the number of the activated relay
Socket for connecting 1-wire devices
Socket for connecting external telecommunication devices via
RS-485/232 interfaces
Power supply indicator in the device
Reset button to reset the device to default settings (carried out
when the Reset button is pressed during power up (turning on
the device), the external battery module must be disconnected
Connector for connecting an external battery module NetPing
external battery module 85M2
Connector for connecting an external 12V power supply:
DJK-02A for a pin 2.1 mm "+" power in the center
Power line for external sensors 5V 300mA to power external
sensors and 1-wire
Power line for external sensors 12V 250mA for powering
external sensors, including IO and 1-wire
General contact
Analog output (DAC)
Relay contacts for switching up to 60VDC 200mA, 60VAC 300mA,
24VDC 500mA, 24VAC 1A - 4pcs relays * 3 contacts (NO,COM,NC)
Discrete inputs with a level of 12V, the input impedance is
4k7-10K. The level of logical "1" is not less than 8.3V, the level
of logical "0" is not more than 3.7 V. Overvoltage protection
above 12.7 V is provided
[ENG] 5. [DKST 57]Sockets and Indication Elements
–