[Eng] 7. [Dkst 57]Connection Of External Sensors And Actuators; Connected Sensors And Actuators; Sensors Of The 1-Wire Model Range; Sensors Of The "Dry Contact" Type - NetPing Input+Relay R404 User Manual

[ENG] NetPing Input+Relay R404, User guide -[ENG] 7. [DKST 57]Connection of external sensors and actuators.

[ENG] 7. [DKST 57]Connection of external sensors and actuators.

It is strictly forbidden to connect sensors and external modules to NetPing devices when the power is on!
To configure the device and receive notifications from sensors, see the document "Description of the
firmware"

Connected sensors and actuators:

This device supports the connection of the following equipment:
•

Sensors of the 1-Wire model range;

•

Sensors of the "Dry contact" type;

• Two-wire sensors;
• Executive devices.
Sensors of the 1-Wire model range
Sensors and accessories of the model range 1-Wire
NetPing Power Quality Monitoring Sensor 1-wire
1W connectors with RJ12 plugs with the possibility of using extension cords and splitters. The maximum length of a
1-Wire network loop for one pair of connectors (lower + upper) is limited to 50 meters. The pairs of connectors are
isolated. The total length of a pair of connectors can be increased by using
meters.
Sensors of the "dry contact" type
Sensors of the "dry contact" type include door opening sensors, buttons and other sensors, the principle of
operation of which is based on the closure / opening of the conductor. The sensor is connected by two wires to the
INPUT line of the device according to the table. The order of wiring does not matter.
Wire
First wire
Second wire
Important! Sensors of the "dry contact" type: a 220V sensor, a leak sensor and others are connected to the INPUT
lines of the device. You can connect 16 of any sensors from this set.
The length of the loop from the sensor to the tail device should not exceed 100 m. If necessary, the length of the
native loop can be increased
mm2.
(Temperature sensor 1-wire (THS), Humidity sensor 1-wire (HS),
910S21,
Одна из INPUT линий – 1 - 16
GND
cable 4 extender, 4m. Or independently using any wire with a cable of at least 0.4
NetPing Converter 0-20mA,
NetPing 1-wire hub, R912R2
Terminal
[ENG] 7. [DKST 57]Connection of external sensors and actuators.
886A02) they are included in
up to 300
–