Leak Sensor; Netping Supply Voltage Sensor 995S2 - NetPing Input+Relay R404 User Manual

[ENG] NetPing Input+Relay R404, User guide -[ENG] 7. [DKST 57]Connection of external sensors and actuators.
The sensor has two connectors on different sides 6p6c for connecting to a monitoring device and 4p4c for
connecting a sensitive cable

Leak sensor

The leakage sensor is connected with a four-wire line in accordance with the table:
Colored wire
Important! Sensors of the "dry contact" type: 220V presence sensor, leakage sensor and others are
connected to the INPUT lines of the device. You can connect any 16 sensors from this set.
The sensor comes with a non-detachable cable with lugs at the ends.
using cable 4 extender,
cable section of at least 0.4 mm2. The maximum permissible loop length is 100 meters.

NetPing Supply Voltage Sensor 995S2

The 220V presence sensor is connected with a three-wire line in accordance with the table.
leak sensing cable
Green
Yellow
Brown
White
4m, which are connected in series into each other, or independently using any wire with a
WLC10.
The cable length can be increased by
[ENG] 7. [DKST 57]Connection of external sensors and actuators.
Terminal
IN1 ... IN16
GND
+5V
GND
–