Applying Dc Output; Performing Measurement - Keysight Technologies B2900B Series Quick Reference

Applying DC Output

B2900 applies a constant voltage of +500 mV by the following procedure.
1. Set the source mode and the Source value.
a. Press the View key to
display the Single view.
1: Single
Source is set to +500 mV.
2 Set the Limit value.
a. Press the Limit assist key.
3. Press the Ch1
the voltage specified by the Source value. Changing the setup changes channel output immediately.

Performing Measurement

Press to start a single measurement.
Press to start a repeat measurement.
* You can change the measurement parameter by
using the Measure assist key.
Disabling the Channel
Press the Ch1 switch to disable channel 1.
This turns off the switch light.
b. Press the Mode assist key.
e. Edit the value as follows or in the same way as for 2-b.
b. Edit the value as follows or in the same way as for 1-e.
switch to enable channel 1. This turns the switch green. Channel 1 starts applying
(1) Change the value
(2) Press the unit assist
key to fix value
(2) Change the value
(3) Press the rotary
knob to fix the value
(1) Move the digit pointer
This is the measurement example for a 1 kW resistor.
c. Press the VOLTS (V) assist key.
d. Press the Source
Measured value
assist key.
Limit value is set to
+10 mA.