CDA VC820 Use And Maintenance page 20

Cleaning the milk container (N)
Always clean the tubes inside the milk container when you prepare
milk. If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary. Clean the container
each time you prepare milk as described in the section "Making
cappuccino". All components can be washed in a dishwasher,
placing them in the top basket of the dishwasher.
1. Turn the milk container lid clockwise then remove it (Fig. 33)
2. Remove the milk spout (S) and intake tube (M) (Fig. 34)
Fig. 33
3. Remove the frothed milk regulator (F) by pulling it outwards
(Fig. 35)
4. Wash all the components thoroughly with hot water and mild
washing-up liquid. Make sure there are no milk residues left
inside the holes (H) and the groove (G) on the fine end of the
frothed milk regulator (F) as shown in Fig. 36
G
F
Fig. 35
38 | Instruction Manual
Fig. 34
S
M
H
H
Fig. 36
5. Check that the intake tube and spout are not clogged with
milk residue
6. Replace the frothed milk regulator, milk spout and intake
tube
7. Replace the milk container lid
Cleaning the nozzles
Clean the nozzles on the milk container every time after heating
milk or making cappuccino. Otherwise, remains of milk may set
hard.
Warning! Risk of scalding from steam and hot
water escaping from the milk dispenser pipe.
1. Place a container under the milk
dispenser pipe and press on the
CLEAN button (N3) on the milk
container for at least 5 seconds. The
display shows "CLEANING!"
2. Remove the milk container and clean
the nozzles on the appliance with a
damp cloth (fig.21)
3. Put the hot water nozzle back in (fig.
22)
Fig. 38
Fig. 37
N3
Fig. 39
Instruction Manual | 39