Table of Contents
Advertisement
Do not use washing up liquid to clean the brewing unit.
It would remove the lubricant applied to the inside of the
piston.
5. Soak the brewing unit in water for about 5 minutes, then
rinse
6. After cleaning, replace the brewing unit (L) by sliding it onto
the internal support (S) and pin (P) at the bottom, then push
the 'PUSH' symbol fully in until it clicks into place. (Fig. 31)
Note: If the brewing unit is difficult to insert, you must first
adapt it to the right dimensions by pressing it forcefully
from the bottom and top (Fig. 30).
S
P
Fig. 29
7. Once inserted, make sure the two red buttons have snapped
back out, otherwise the service door cannot be closed
•
The two red buttons are correctly snapped out (Fig. 31)
•
The two red buttons are not snapped out (Fig. 32)
8. Replace the drip
tray and waste
coffee container
9. Close the service
door
36 | Instruction Manual
Fig. 30
Fig. 31
Fig. 32
Notes
•
If the brewing unit is not put in place correctly, the service
door cannot be closed
•
If it is difficult to insert the brewing unit, it must be made into
the right height (before inserting) by pressing the brewing
unit firmly together from top and bottom
•
If it is still difficult to insert the brewing unit:
•
Leave it out of the appliance, place the drip tray, close
the service door, switch the main switch on the back of
the appliance to 'off' and then to 'on' again
•
Wait for all the lights to go off, then open the door,
remove the drip tray and replace the brewing unit
•
Replace the drip tray, together with the waste coffee
container
•
Close the service door
Instruction Manual | 37
Advertisement
Table of Contents
