Table of Contents
Related Manuals for CDA CVC10SS
Summary of Contents for CDA CVC10SS
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
-
Page 2: Appliance Information
Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model... -
Page 3: Coffee Machine
Coffee machine COFFEE MAKER CVC10 CONTROL PANEL 1 - Display 2 - Control panel 3 - Dispenser spout 4 - Steam nozzle 5 - Drip tray drawer Control panel COFFEE MAKER CVC10 CONTROL PANEL 1. Power Button – Press to turn the machine on and off. (Standby) 2. -
Page 4: First Use
First use This coffee machine has two water heaters, one for the water and one for the coffee, which allows for ideal temperatures for coffee and steam for cappuccino. The steam can also be used to preheat the cups. This coffee machine can grind coffee beans when they are needed, ensuring they are freshly ground for the very best flavour. - Page 5 To fill the coffee container: Pull the machine out of its housing by lifting the handle of the machine and pulling it towards you. Remove the lid of the coffee container and fill it until the coffee beans are 2cm from the top level. Then replace the lid.
-
Page 6: Dispensing Steam
The Coffee Machine Press to switch on the coffee machine After a few seconds, GOOD MORNING will show on the display. The machine will heat up, and COFFEE and STEAM will flash on the display. Once the machine is ready for use, COFFEE and STEAM will illuminate constantly, as will the size and number of the coffees last selected (for example 1 SHORT). - Page 7 5. Make a cappuccino We recommend preparing cappuccinos individually so as to ensure best flavour. Make a medium espresso as described above in a large cup. Press to select steam and wait until STEAM stops flashing. Before putting the container under the steam nozzle, press and hold flush out any water remaining in the pipes.
- Page 8 Programming The coffee machine is equipped with a programming mode to enable you to set the following as required: To enter programming mode follow the steps below: Whilst the machine is off, press and hold Press To change the setting, press Press to exit programming mode.
-
Page 9: Care And Maintenance
Care and Maintenance DO NOT PERFORM ANY MAINTENANCE OR CLEANING WITHOUT FIRST SWITCHING OFF THE POWER SUPPLY. THE COFFEE MACHINE WILL BE HOT IMMEDIATELY AFTER USE. ALLOW IT TO COOL BEFORE CLEANING. As the coffee machine has a stainless steel and glass surface, you should use a nonabrasive cleaner. Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings. - Page 10 Care and Maintenance Descaling If the display shows DESCALING then the coffee machine needs to be descaled to ensure best performance. Please note: You should use cleaning products that are appropriate for use with coffee machines. Do not use lemon-based products to descale the coffee machine as these can cause irreparable damage to the coffee machine.
-
Page 11: Troubleshooting
DESCALING Descale the coffee machine TECHNICAL SERVICE Before calling CDA Customer Care, first trying pulling the coffee machine out and pushing it back in fully. WATER PRESSURE Check the water tank is full and then open the water dispensing tap, letting water out of the steam nozzle until the display stops flashing. -
Page 12: Installation
Installation IMPORTANT: THIS APPLIANCE SHOULD BE FITTED BY SUITABLY QUALIFIED PERSON. Slide the base unit into the housing ensuring the dimensions are correct as per figure 1. Fix the base unit in place by attaching the 10 screws in to the holes as shown in figure 2 and figure 3. - Page 13 To reduce the risk of electric shock, do not mount over a sink. The water supply should be located in a place that allows the machine to be isolated in the event of an emergency. CDA will not be held responsible for water leaks caused by incorrect installation. fig. 4 ...
-
Page 14: Electrical Information
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. - Page 16 Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...