Cleaning And Maintenance - Vitek VT-1761 Manual Instruction

«Night» mode on/off button (20) «
To turn the «night» mode on press the button
–
(20), to turn the «night» mode off press the but-
ton (17) again.
AIR HUMIDIFIER OPERATION
• Open the water tank lid (1) to add water as
shown in the figure (fig. 2).
•
Fill the tank (2) with water not exceeding the maxi-
mum mark and close the lid. The process chamber
will be automatically filled with water after a while.
Notes:
it is recommended to use water that was addi-
–
tionally cleaned with a domestic water filter,
softened water or distilled water. The water tem-
perature should not exceed 40°C.
the «MAX» level maximum mark is placed at the
–
end of the air pipe of the water tank (2) (fig. 2).
•
Insert the power cord plug into the socket,
you will hear a sound signal and the indicators
(11, 12, 13) on the control panel (10) will briefly
light up.
•
Switch the air humidifier on by touching the
« » button (15), the ON indicator (12) will light
up with green.
• Then set the desired mist release intensity by
consequently touching the button (16), the cor-
responding indicators (11) on the control panel
(10) will light up.
•
Turn the lid (1) to set the desired direction of the
«mist» release.
Notes: - to aromatize air in the room, open the lid
(1) and add some drops of water-soluble essential
oil directly in the water tank (2).
Low water indication
•
When the water in the water tank (2) and the pro-
cess chamber (9) runs out, you will hear three
short sound signals, and the indicator (12) will
light up with red.
•
Add water to the water tank (2) in accordance
with the instructions above.
•
After finishing the operation turn the air humidi-
fier off by touching the button (15), the ON indi-
cator (12) will go out. Unplug the unit.

CLEANING AND MAINTENANCE

Warning! Always switch the air humidifier off and
unplug it before maintenance works or cleaning.
Due to geographical factors, water quality may vary
from place to place. In some places, water is hard
and contains large amounts of calcium and magne-
sium ions. In addition, the use of bleaching agents
(for water purification) also increases the water hard-
ness. When such water is used to humidify the air, the
calcium and magnesium ions are dispersed along
with the «mist». Hard water causes the appearance
of mineral scale on the «sprayer» (8), in the process
»
chamber (9) and in the water tank (2); it leads to
improper operation of the humidifier and appearance
of white deposits on interior objects. To avoid this, it
is necessary to clean the water tank (2), the filter (3),
the process chamber (9) and the «sprayer» (8), and
change the water in the tank (2) as often as possible.
Water tank
•
The water tank (2) should be cleaned once every
3 days.
Water should be changed more often. Do not leave
the water in the tank for more than 2 days.
Filter
Its function is to purify water, filter organic sub-
stances, heavy metals, suspensions, colloidal sub-
stances, and impurities in water.
•
The installed filter (3) does not need to be
replaced, remove it from the water tank (2) every
3-5 days, remove the filter element and rinse it
with tap water, and then place it back (fig. 3).
Notes: - the filter (3) cannot completely clean the
water from mineral deposit and is an additional
means of water cleaning.
Process chamber with sprayer
•
Once a week, thoroughly rinse the process
chamber (9) and the «sprayer» (8) with a neutral
detergent solution.
•
Then rinse with water carefully.
•
Add 5-10 drops of the detergent on the «sprayer»
(8) and wait for about 2-5 minutes. Remove the
deposit from the «sprayer» (8) surface with a
soft brush.
•
If there is also scale on the float (4) and the water
level detector (5), use a cleaning agent.
Notes: You can use descaling agents for kettles as
a cleaning agent for the sprayer.
• Clean the unit body (7) with a slightly damp soft
cloth, and then wipe it dry.
•
Do not immerse the air humidifier body (7), the
power cord and the power plug into water or any
other liquids. Provide that no liquid gets inside
the air humidifier body (7).
•
Do not use solvents or abrasives to clean the
surface of the body (7) and the water tank (2).
STORAGE
•
If you are not going to use the unit for a long time
and want to put it away for storage, make sure
that all its parts are dry, including the process
chamber (9), the «sprayer» (8) and the filter (3).
•
Do not store the unit with water in the tank (2)
and in the process chamber (9).
•
Keep the air humidifier away from children in a
dry, dark and cool place.
5
ENGLISH