Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
Unpack the unit, remove any stickers and pack-
–
age materials that can prevent unit operation.
Check the unit for damages. In case of damages
do not switch the unit on.
Remove the water tank (4) and remove a trans-
–
porting plastic part (pic. 1).
A protective transport gasket is installed under
–
the movable float (4) in the process cham-
ber (9).
Lift the water tank (2) and remove the float (4)
–
soft transport gasket (fig. 1). Then install the
water tank (2) back on the unit body (7).
Before plugging the unit in make sure that your
–
home mains voltage corresponds to the unit
operating voltage.
Notes:
Use the humidifier at the room temperature
–
from +10° С to +40° С, and relative humidity less
than 80%.
Water temperature should not exceed +40°С.
–
AIR HUMIDIFIER OPERATION
•
Open the water tank lid (1) to add water as
shown in the figure (fig. 2).
•
Fill the tank (2) with water not exceeding the
maximum mark and close the lid. The process
chamber will be automatically filled with water
after a while.
Notes:
it is recommended to use water that was addi-
–
tionally cleaned with a domestic water filter,
softened water or distilled water. The water tem-
perature should not exceed 40°C.
the «MAX» level maximum mark is placed at the
–
end of the air pipe of the water tank (2) (fig. 2).
•
Insert the power plug into the mains socket.
•
Switch the air humidifier on by turning the con-
trol (10) clockwise; the ON indicator (11) will light
up green.
•
Next, turn the control (10) clockwise to set the
desired «mist» release intensity.
•
Turn the lid (1) to set the desired direction of the
«mist» release.
Notes: - to aromatize air in the room, open the
lid (1) and add some drops of water-soluble essen-
tial oil directly in the water tank (2).
•
If the water tank (2) and the process chamber
(9) are empty, the indicator (11) will light up red.
•
After finishing the operation, switch the air
humidifier off by turning the control (10) coun-
terclockwise until you hear a click, the indicator
(11) will go out. Unplug the unit.
CLEANING AND MAINTENANCE
Warning! Always switch the air humidifier off and
unplug it before maintenance works or cleaning.
Due to geographical factors, water quality may vary
from place to place. In some places, water is hard
and contains large amounts of calcium and magne-
sium ions. In addition, the use of bleaching agents
(for water purification) also increases the water
hardness. When such water is used to humidify
the air, the calcium and magnesium ions are dis-
persed along with the «mist». Hard water causes the
appearance of mineral scale on the «sprayer» (8), in
the process chamber (9) and in the water tank (2);
it leads to improper operation of the humidifier and
appearance of white deposits on interior objects.
To avoid this, it is necessary to clean the water tank
(2), the filter (3), the process chamber (9) and the
«sprayer» (8), and change the water in the tank (2)
as often as possible.
Water tank
•
The water tank (2) should be cleaned once every
3 days.
Water should be changed more often. Do not leave
the water in the tank for more than 2 days.
Filter
Its function is to purify water, filter organic sub-
stances, heavy metals, suspensions, colloidal sub-
stances, and impurities in water.
•
The installed filter (3) does not need to be
replaced, remove it from the water tank (2) every
3-5 days, remove the filter element and rinse it
with tap water, and then place it back (fig. 3).
Notes: - the filter (3) cannot completely clean the
water from mineral deposit and is an additional
means of water cleaning.
Process chamber with sprayer
•
Once a week, thoroughly rinse the process
chamber (9) and the «sprayer» (8) with a neutral
detergent solution.
•
Then rinse with water carefully.
•
Add 5-10 drops of the detergent on the «sprayer»
(8) and wait for about 2-5 minutes. Remove the
deposit from the «sprayer» (8) surface with a
soft brush.
•
If there is also scale on the float (4) and the water
level detector (5), use a cleaning agent.
Notes: You can use descaling agents for kettles as
a cleaning agent for the sprayer.
•
Clean the unit body (7) with a slightly damp soft
cloth, and then wipe it dry.
•
Do not immerse the air humidifier body (7), the
power cord and the power plug into water or any
other liquids. Provide that no liquid gets inside
the air humidifier body (7).
•
Do not use solvents or abrasives to clean the
surface of the body (7) and the water tank (2).
4
Advertisement
Table of Contents
