Cleaning And Maintenance; Troubles And Troubleshooting - Vitek VT-1762 Manual Instruction

Hide thumbs Also See for VT-1762:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
– Before plugging the unit in make sure that your
home mains voltage corresponds to the unit
operating voltage.
Notes:
– Use the air humidifier at the room temperature
from +10°C to +40°C, and relative humidity less
than 80%.
– Water temperature should not exceed +40°C.
ON/OFF button (4) «
»
Touch the button (4) to switch the unit on and touch
the button again to switch the unit off.
Mist release intensity control button (3) «
– Consequently pressing the button (3), you can
select the mist release intensity: low (green
lighting of the button (3)) and high (blue lighting
of the button (3)).
Notes: when you switch the unit on for the first
time, low mist release intensity is set automatically.
AIR HUMIDIFIER OPERATION
• Remove the water tank lid (1) to fill the tank with
water.
• Fill the water tank (2) with water not exceeding
the maximal level mark and close the lid.
Notes:
– it is recommended to use water that was addi-
tionally cleaned with domestic filter, softened
or distilled water. The water temperature should
not exceed 40°С.
• Insert the power plug into the mains socket, the
buttons (3, 4) illumination will light up for a short
time.
• Switch the air humidifier by pressing the button (4)
«
», the button (3) lighting will light up green.
• Then set the desired mist release intensity by con-
sequently pressing the button (3).
Low water indication
– When the water tank (2) becomes empty, the
button (4) lighting will start flashing red.
– Add water to the water tank (2) as described above.
– After the humidifier finishes operation, switch
it off by pressing the button (4), the button (4)
lighting will go out. Unplug the unit.

CLEANING AND MAINTENANCE

Warning! Always switch the air humidifier off and
unplug it before maintenance works or cleaning.

TROUBLES AND TROUBLESHOOTING

Malfunction
The button (3) lighting does
not light up and no «mist» is
released.
Due to geographical factors, water quality may
vary from place to place. In some regions water is
hard and contains a large number of calcium and
magnesium ions. In addition, the use of bleach-
ing agents (for water purification) also increases
the water hardness. When such water is used to
humidify the air, the calcium and magnesium ions
are dispersed along with the «mist». Hard water
causes the appearance of mineral scale on the
«sprayer» (6) and on the water tank (2); it leads to
improper operation of the humidifier and appear-
ance of white deposits on interior objects. To
avoid this, it is necessary to clean the water tank
»
(2) and the «sprayer» (6) and to change water in
the tank (2) as often as possible.
Water tank
• Clean the water tank (2) every 3 days. Water
• Once a week wash the water tank (2) and the
• Then rinse with water carefully.
• Add 5-10 drops of the detergent on the «sprayer»
• If scale appeared on the float (5) as well, use the
Notes: You can use descaling agents for kettles as
a cleaning agent.
• Wipe the humidifier body with a soft, slightly
• Do not immerse the humidifier body, the power
• Do not use solvents or abrasives to clean the
STORAGE
• If you are not going to use the unit for a long time
• Do not store the unit with water in the water
• Keep the air humidifier away from children in a
Possible causes
Troubleshooting
No supply voltage.
Connect the unit to the mains.
Plug another, known good appliance to the socket
to make sure that the socket works properly.
4
should be changed more often. Do not leave the
water in the tank for more than 2 days.
«sprayer» (6) carefully with a neutral detergent
solution.
(6), wait for about 2-5 minutes. Remove the
deposit from the «sprayer» (6) surface with a soft
brush.
detergent.
damp cloth and then wipe it dry.
cord and the power plug into water or other
liquids. Provide that no liquid gets inside the
humidifier body.
surface of the body and the water tank (2).
and want to take it away for storage, make sure
that all its parts are dry, including the water tank
(2) and the «sprayer» (6).
tank (2).
dry, darkened and cool place.

Advertisement

Table of Contents
loading

Table of Contents