Adjustment And Use Of Slide Construction Set-Up Rs And Rf - Landustrie LANDY BTP62-40 Operation & Maintenance Manual

7.6.8 Adjustment and use of slide construction set-up RS and RF

4
Pump adjustment on existing pipework after base plate installation:
1. Remove the bolts, pos.1, from the pump housing and keep them.
2. Tighten nuts, pos.3 and bottom 2 nuts, pos. Something 6 loose.
3. Use forcing bolts pos.2 to roll the pump out of the pump housing and tighten the bottom nuts
pos. 6 again.
4. Unscrew bolts, pos. 4 slightly loose. Install the pump housing on the existing pipework. Tighten
bolts pos. 4 back into position.
5. Unscrew the bolts and upper nuts, pos. 5 slightly loose. Also loosen the bottom nuts pos 6 a
little.
6. Roll the pump towards the pump housing and adjust pos.5 so that the pump can roll smoothly
into the pump housing.
7. Tighten the bolts and nuts of pos.5 in position
8. Roll the pump into the pump housing and retighten bolts pos.1 in the pump housing. Make sure
that forcing screws pos.2 are unscrewed far enough.
9.Unscrew the lower nuts from pos. 3 so that the wheels are not under tension. Then tighten the
top nuts.
10. Tighten the lower nuts from pos. 6 fixed.
Use carriage assembly for maintenance:
1. Remove the bolts, pos.1, from the pump housing and keep them.
2. Unscrew nuts, pos.3 and bottom 2 nuts, pos. 6 loose.
3. Use forcing bolts pos.2 to roll the pump out of the pump housing and tighten the bottom nuts
pos. 6 again.
4. After maintenance, unscrew the bottom nuts of pos. 6 and roll the pump back into the pump
housing.
5. retighten the bolts, pos.1, in the pump housing. Make sure that forcing screws pos.2 are
unscrewed far enough.
6. Unscrew the lower nuts from pos. 3 so that the wheels are just under tension. Then tighten the
top nuts.
7. Tighten the lower nuts from pos. 6
Landustrie version 06-14 | Operation & Maintenance manual BTP-SERIES
Subject to modifications
1
2
3
5
1. 1. Pump housing mounting bolts
2. 2. Pump housing forcing screws
3. 3. Sled anchoring
4. 4. Pump housing adjustment
5. 5. Slide assembly adjustment
6. 6. Roll-off security
6
20 / 28