These instructions, including the wiring diagram, are necessary for safe installation. Usage limitations: The DCP22 pumps are developed for normally contaminated municipal waste water. The pumps in Basic Version may not be installed in potential explosive atmospheres Landustrie versie 01-21 | Operation & maintenance manual DCP22...
Please be also aware that some of the components can be very useful for reuse. The owner is responsible for careful disposal and processing of the materials. Do this in according to the local environmental regulations. Landustrie versie 01-21 | Operation & maintenance manual DCP22 4 / 16 Subject to modifications...
At full load conditions, at least 2/3 of the motor housing should be submerged. The pump casing must stay under water to avoid air being drawn in. Landustrie versie 01-21 | Operation & maintenance manual DCP22 5 / 16...
Hoisting device: Submersible pumps can be hoisted out of the sump by means of an adequate lifting device. Landustrie is able to deliver this certified equipment. Hoisting cable: If applied, please replace the stainless steel hoisting cable every two years, or accordingly to local regulations.
We do strongly recommend to connect the pump to the mains by authorized personal only. Please ensure this is done accordingly and in compliance with local regulations. Landustrie versie 01-21 | Operation & maintenance manual DCP22 7 / 16 Subject to modifications...
1x 7 core cable GN/YE Green/Yellow T1, T2 Klixons (or thermistors) Water in oil detection L1,L2,L3 3 phase line Motor in delta Motor in star Landustrie versie 01-21 | Operation & maintenance manual DCP22 8 / 16 Subject to modifications...
Without klixons and/or water in oil detection 1x 7 core kabel GN/YE Green/yellow L1,L2,L3 3 phase line With klixons and or water in oil detection 1x 10 core cable Landustrie versie 01-21 | Operation & maintenance manual DCP22 9 / 16 Subject to modifications...
Change the oil if not transparent. Lubricants: The bearings of the pump are greased for life. Standard oil type for the mechanical seals: Shell Tellus 32, viscosity 32 cSt. Landustrie versie 01-21 | Operation & maintenance manual DCP22 10 / 16 Subject to modifications...
Page 11
If not so fill up to the right level. The drain plug (3) is located at the bottom side. Always use the right kind of oil ! Landustrie versie 01-21 | Operation & maintenance manual DCP22 11 / 16 Subject to modifications...
If necessary, re-adjust the mounting and adjusting screws. The play between the impeller and the suction cover has to be about 0,6 mm. Now the pump is operational again. Landustrie versie 01-21 | Operation & maintenance manual DCP22 12 / 16 Subject to modifications...
EC Declaration of conformity: Service Contract: Although the quality standards of the Landustrie pumps are very high, we do strongly recommend to close a service contract with your local supplier. For service- or technical information, please contact: Verhelpen van storingen: Landustrie versie 01-21 | Operation &...
Need help?
Do you have a question about the DCP22 and is the answer not in the manual?
Questions and answers