Maintenance; General; Maintenance Schedule; Lubricants - Landustrie LANDY BTP62-40 Operation & Maintenance Manual

7. MAINTENANCE

7.1 General:

Always disconnect the pump from the mains before inspection or disassembly.
Clean the pump thoroughly.

7.2 Maintenance schedule


After the first 100 running hours:
- Check the oil (see chapter 7.4).
- If there is more than a few drops of water in it, contact your dealer.
 Every 6 months or 1000 running hours:
- Check the oil (see chapter 7.4).
- If there are more than a few cm
 Refresh the oil every year or when it is no longer transparent. (see chapter 7.5)

7.3 Lubricants:

 The bearings are greased for life and needs no refill.
 The oil reservoir is filled with Shell Tellus 32 or an equivalent.
Viscosity: 32 cSt.
When another kind of oil is used this is marked on a label on the pump.

7.4 Oil level:

Check the oil level in the oil tank.
The oil plug has a gauge rod and the level should be between the two marks.

7.5 Oil change:

Collection, storage and removal of the oil should be executed according to the
regulations of the local authorities.
Always use the right kind of oil!
To drain the oil, remove one of the oil pipes, or use the drain pipe.
We advise to flush the system with fresh oil, before filling it up.
Landustrie version 06-14 | Operation & Maintenance manual BTP-SERIES
Subject to modifications
water in it, contact your dealer.
3
14 / 28