Infopia Element Plus Owner's Manual page 7

Comparing your meter and laboratory results
You tested at a temperature near the low end of the operating range
which could result in a false high blood sugar.
Repeat the test in a warmer environment with a new test strip as soon as
possible.
For additional information on possible limitations for accuracy on
precision, please refer to your test strip insert.
In order to make the most accurate comparison to your laboratory
results. Please follow a few basic guidelines:
Before going to the lab
- Do not eat for at least two hours before you test your blood.
- Perform a control solution test to make sure the meter is
working properly.
- Take your meter with you to the lab.
While at the lab
- Follow all instructions in this owner's booklet for performing a
blood sugar test with your meter.
- Conduct your meter test within 15 minutes of lab test.
- Use only fresh, capillary blood obtained from the fingertip.
You may still experience a difference from the laboratory test results
because blood sugars can change very rapidly over a short period of
time. This can be for a variety of reasons, such as; exercise, medication,
stress or loss of body fluids.
14/ 15 www.infopiausa.com
Setting Your Meter Setting Your Meter
The Element The Element TM TM Plus meter has a wide variety of functions to choose from. Plus meter has a wide variety of functions to choose from.
From the setup mode you have the ability to turn on the voice feature, From the setup mode you have the ability to turn on the voice feature,
activity/meal flags, set the date/time, designate three unique averages activity/meal flags, set the date/time, designate three unique averages
and set up to five daily alarms. and set up to five daily alarms.
Select Speaking Function Select Speaking Function
Press and hold the power button Press and hold the power button
seconds to enter the setup mode. The word "Voice" will seconds to enter the setup mode. The word "Voice" will
appear in the lower right corner of the LCD screen indicating appear in the lower right corner of the LCD screen indicating
the Voice Feature. Press and release either the the Voice Feature. Press and release either the
button to turn the Voice Feature on or off, then press and button to turn the Voice Feature on or off, then press and
release release
Select Language(English or Spanish) Select Language(English or Spanish)
If you chose to turn On the voice feature, the next option If you chose to turn On the voice feature, the next option
is for you to choose your desired language preference. is for you to choose your desired language preference.
The letters "L-1" indicating Language-1 and "En" The letters "L-1" indicating Language-1 and "En"
indicating English will appear. indicating English will appear.
or or
If English is your desired language then press and If English is your desired language then press and
release release
If Spanish is your desired language press ▲ or ▼ for If Spanish is your desired language press ▲ or ▼ for
letters "L-2" indicating Language-2 and "ES" indicating letters "L-2" indicating Language-2 and "ES" indicating
Español(Spanish), then press Español(Spanish), then press
Note: Note:
TM TM
The Element The Element Plus meters language is set to English by default. This Plus meters language is set to English by default. This
default setting will remain whenever the meter is powered on or after a default setting will remain whenever the meter is powered on or after a
battery change. battery change.
for approximately 3 for approximately 3
. .
. .
. .
Call toll free : 1-888-446-3246 Call toll free : 1-888-446-3246
or or