Setpoints - Daikin WGZ030DW Installation, Operation And Maintenance Manual

Unit Controller
Set points
The following parameters are remembered during power off, are factory set to the Default value, and can be adjusted to any
value in the Range column. The unit controller is also used for TGZ Templifier (R-134a) in HEAT mode, see IOM 1319 on
www.DaikinApplied.com for further information.
The PW (password) column indicates the password level that must be active in order to change the set point.
Passwords are: O = Operator, M = Manager
Table 25: Set points (set points with * are set at Daikin Applied factory)
www.DaikinApplied.com 33 IOM 1322-1 • WATER-COOLED SCROLL COMPRESSOR