Data Logging Status - Mitsubishi Electric MELSEC-L Series User Manual

6.4

Data Logging Status

There are the following data logging states.
• Start
• Pause
• Stop
• Completion
(1) Start
By a data logging start request, register a data logging
following:
• Start operation from the configuration tool (
• Turning on the special relay (Data logging start)
*1 Data logging can be registered by the following:
• Power OFF → ON
• Reset
• STOP → RUN
• Auto logging start
(2) Pause
With the data logging setting registered, the data logging is stopped temporarily. The following operation and
status causes a pause.
• Pause operation from the configuration tool (
• Turning off the special relay (Data logging start)
• The CPU module is in the STOP status. (Including a stop error)
(3) Stop
Registration of the data logging setting in the CPU module is cancelled. The following stops data logging.
• Stop operation from the configuration tool (
Remote latch clear will clear the data logging status, and make it unregistered. To execute data logging again, start it from
the configuration tool. Also, if "Format PLC Memory" is executed to the memory where the currently executing data logging
file is stored, the data logging status will be cleared and left unregistered. To execute the data logging again, write the
configuration of the data logging, and then start it from the configuration tool.
62
*1
and start it. Data logging start can be requested by the
Page 128, Section 8.9)
Page 128, Section 8.9)
Page 128, Section 8.9)