Checking For Blockages - Shark WANDVAC WV361EU Instructions Manual

MAINTAINING YOUR VACUUM
CLEANING THE DUST CUP AND FILTER
1. To deep clean the dust cup and cyclone, use gentle
force to push the filter housing away from the dust
cup until the parts are separated at a 90 degree
angle, as shown above. Locate the wire handle on
the cyclone frame and use this to pull the cyclone
frame out of the dust cup.
Rinse or wipe clean the exposed dust cup and let
air-dry for 24 hours.
CLEANING FLOOR NOZZLE
If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
DIRT ENGAGE™ FLOOR NOZZLE FLOOR NOZZLE
44
s h a r kc l e a n . e u
1
2. When the dust cup is completely dry, put the
cyclone frame back into place, making sure the
wire handle is tucked away before reassembling the
handvac. Use gentle force to reduce the 90 degree
angle between the filter housing and the dustcup.
Reassemble the dust cup and filter housing with a
click back in place inside the handvac body.
1. Turn off the vacuum.
2. Press the nozzle release button to detach the
nozzle from the wand.
3. Using a coin, turn the four locks
counterclockwise to open, then lift off the cover
and tilt back the neck of the nozzle.
4. Clear any blockages and remove any debris
from the brushroll and floor nozzle.
5. Replace the cover by sliding the tabs into the
slots. Press down firmly on all sides. Turn locks
clockwise to close, until they click into place.
2
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings to the dust cup and remove any
debris or blockages.
Checking for Blockages in the Wand:
1. Turn off vacuum.
2. Detach the handheld vacuum and floor nozzle from the
wand.
3. Check both ends of the wand for blockages and debris.
4. Clear away any debris or blockages.
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the four locks on the
bottom of the floor nozzle.
4. Remove the cover and tilt back the neck of the
floor nozzle.
5. Check the opening and remove any debris or blockages.
6. Replace cover by firmly pressing down on all sides and
turning the locks clockwise to close.
45
s h a r kc l e a n . e u