Shark WANDVAC WV361EU Instructions Manual page 21

CHARGING AND STORAGE
CHARGER
Plug the Charger into a wall outlet.
IN CHARGING DOCK
OPTION 1 – IN CHARGING DOCK
When the dock is assembled and plugged in, charge
the unit by placing it on the dock plate, with the
hook on the back of the wand over the charging
post. Make sure the contacts on the wand are
aligned with the contacts on the charging post.
When docked properly, the charging lights on the
handheld vacuum will blink, indicating that charging
has begun. When charging is complete, all three
indicator lights will illuminate steadily.
NOTE: The main unit comes with a partial charge. For maximum runtime, charge fully before first use (approximately
3.5 hours). Leaving the unit plugged in will not damage battery life..
40
s h a r kc l e a n . e u
BATTERY
To remove the battery from the hand vac or
the charging post, press the release tabs on the
battery cap and slide out the battery. To reinstall,
slide the battery into the compartment in the
handle unit it clicks, or into, or into the slot in the
dock charging post.
1
CHARGING HANDHELD VACUUM
OPTION 2 – CHARGING HANDHELD VACUUM
To charge the handheld vacuum alone without the
dock, unplug the charger cord from the dock and
connect it directly to the port on the handheld
vacuum, near the nozzle opening.
POWER
Press the On/Off button on the handle to turn
on ION power. To turn off power, press the
button again.
2
CONTROLS
BOOST MODE
For an added boost in power, press and hold the
Button at the base of the handle of the handheld
vacuum. The Boost light will turn white in this
mode. Release the button to return to standard
power.
s h a r kc l e a n . e u
41