Advertisement
RIBS: Once all the various Rib parts are removed from the carrier sheets; very carefully sand using a
flat sanding board all the perimeters to remove any tab connections and some of the laser cutting char.
Start with Rib WR1 and work through to WR5 adding the Rib Caps (1/32" x 3/32" x 12") starting first
with the bottom edge of the ribs and glue the Cap Strips in place centered on the Rib and hold in place
using small alligator clips with 1/4" of the Cap Strip extending beyond the rear of the Ribs as seen in
the pictures below.
38
Advertisement
