Advertisement
Now with the binding wires still in place cut away the extended support from the Rudder Pivot using a
jeweler's saw and file and sand smooth the saw cuts to match the contour of the Fuselage frame
structure as seen in the picture below. These extensions were cast in place to facilitate correct
alignment of the Fuselage when building.
Now cut away and remove the binding wires with small snips taking care not to snag the Stringers.
Add the rigged turnbuckles to all the Fuselage sides, tops and bottoms starting at the rear and up to
Station 3. The bay between 3 and 2 must be left open to add the Main Gas Tank. See picture above
and on the next page
10
Advertisement
